Materials used for production are carefully selected to meet the highest international standards set by the various product Brands. Diamonds & Colored Gemstones are selected according to the level of the product brand. A rigid quality control system monitors various stages of production to arrest any manufacturing defects at an earlier stage and ensures that only the very best is produced. Stringent quality checks carried out in the final line of production give our customers an item of absolute perfection.
QUALITY CONTROL TESTS
A piece of jewellery set with diamonds using Floating Diamonds setting process was introduced into an oven and heated up to a temperature of 120° Celsius (250° Fahrenheit). Thereafter the oven was switched off and oven doors open. This same piece was also introduced into a freezing compartment and the temperature was brought to -20° Celsius after which is removed.
No damages were noted; no discolouring of setting and no expansion or contraction of the material was noted.
Floating Diamonds jewelry could be exposed to temperature ranging from -20° Celsius to +20° Celsius (250° Fahrenheit) with no damage caused to the setting or to the piece of jewellery. Outside this temperature range the carbon compound begins to crystallize.
The Floating Diamonds piece of jewellery was dropped from a normal desk top height over a hundred times to a concrete floor.
No damage was caused to the setting, except a few scratches on the gold which is justifiable.
There can be no damage caused to the Floating Diamonds Setting when of normal use.
The Floating Diamonds jewellery was put into a metal container with a 4” diameter and rolled a distance of 20 feet with a recorded number of 50 revolutions.
No damage was caused to the setting, except a few scratches on the gold which is justifiable.
There will be no damage caused if the jewellery is in a container and then thrown around..
A layer of nail varnish was applied on the Floating Diamonds jewellery and using nail varnish remover the varnish was removed.
No damaged was caused to the setting, the same brilliance and luster was brought back to the piece of jewellery.
In the event nail varnish spills on the setting, with no fear one could remove it by using nail varnish remover.
Sulfuric 10% with water 90% (the normal formula used to clean jewellery) was used to dip the jewellery for 1 minute and 30 seconds and cleaned in water and dried under normal condition.
No effect was noted.
Any jeweller can clean your Floating Diamonds jewelry using the normal cleaning methods, with no damage caused to the jewellery.
Jewellery cleaner 10% with water 90% was used in the Ultrasonic Machine to clean frame of Floating Diamonds jewellery for 10 minutes. The frame was checked every minute for damages and colour changes in the Floating Diamonds Setting.
No effect was noted.
Any Ultrasonic Machine can be used with jewellery cleaner to clean a Floating Diamonds Setting without causing any damage or colour change to the setting. Above 10 minutes there may be some separation of the setting from the frame.
Used a normal buffing machine to polish a frame of a Floating Diamonds Setting until the frame became very hot...
No effect was noted in the Floating Diamonds Setting. Only the gold frame was damaged due to wear off.
Any normal buffing machine can be used to polish a Floating Diamonds set gold frame without causing any damage or co lour change to the setting.
A piece of Floating Diamonds jewellery was soaked in perfume for 30 minutes.
No damaged to the Floating Diamonds Setting piece of jewellery was noted and no discolouration.
Any Cologne / Perfume can be used while the Floating Diamonds jewellery is worn..
A piece of Floating Diamonds jewellery was placed under direct sun light for a period of 8 hours each day for 2 days.
No discolouration, no damage to the Floating Diamonds Setting process.
In normal use prolonged exposure to sun light or other lighting will not discolour or damage the piece of Floating Diamonds jewellery.